Skip to main content

Specification · 5 min read

How to match an existing Brazilian cherry floor

Why new Jatoba never matches an aged floor on day one, how to compare boards properly, and when to transition instead of blending.

Why new boards will not match on day one

Jatoba ambers with light exposure. A floor that has been down for several years has already deepened from a golden red into a burgundy-brown, while freshly milled boards start noticeably lighter and pinker. Expect a visible difference at installation that narrows over the following months.

Because of that, judge a match on species, dimensions, grain and finish first. Colour is the one variable that time partly corrects.

What to check on the existing floor

Pull a register cover or a threshold and measure a board where you can see its full edge. Bring a loose piece to the showroom if you have one.

  • Thickness — Sunca solid Jatoba is 3/4"; engineered Jatoba is 18 mm with a 3.5 mm top layer
  • Width — Sunca solid Jatoba comes in 3 1/4" and 4 1/2"; engineered in 5.5"
  • Finish — prefinished with a factory bevel, or site-finished with square edges
  • Sheen — Sunca prefinished floors carry a 10% sheen; older floors may be glossier
  • Stain — natural Jatoba or a tone such as coffee, truffle, caramel, rose or burgundy

Blend, refinish or transition

If the addition runs straight into the old floor, the most even result is to install the new boards and then sand and refinish both areas together. That resets the sheen and lets the colour age as one floor.

If refinishing is not an option, break the run at a doorway with a threshold or a change in board direction. A clean break reads as intentional; a weave-in across an open room shows every difference.

When weaving in prefinished boards, rack from several boxes, keep new boards out of direct sunlight until they are installed, and tell the client the new area will keep darkening toward the old one.

Frequently asked

Can new Brazilian cherry match a floor that is ten years old?
Not exactly on day one. New Jatoba starts lighter and ambers over the first months. Matching species, width, thickness and finish, then letting the new boards age or refinishing both areas together, gives the closest result.
What sizes does Sunca stock in Brazilian cherry?
Solid Jatoba at 3/4" thick in 3 1/4" and 4 1/2" widths, and engineered Jatoba at 18 mm thick and 5.5" wide with a 3.5 mm top layer.

Need this checked against a live job?

Send us the subfloor, the readings and the product you're planning to use. We'll tell you whether it works before the material ships.

Ask the Sunca team
15 Connie Crescent, Unit 12-13, Concord, ON L4K 1L3